CounterhoopVintage drums and instruments — by musicians, for musicians. Cart 0

In stock › Categories › Snare Butt Plates

Vintage Snare Butt Plates

22 one-of-a-kind pieces in stock. Every piece is photographed, honestly graded, and sold as described.

The butt plate anchors the snare wires opposite the throw-off and takes constant tension, so check for stripped threads and bent ears. Maker-matched pairs (strainer and butt from the same manufacturer and era) are what collectors expect to see.

Adjustable butts allow fine wire tension from both ends; fixed plates are period-correct for earlier drums. Either way, confirm the mounting holes line up with your shell's drilling.

The butt anchors the wires opposite the throw-off and takes constant tension, so check for stripped threads and bent ears. Maker-matched pairs (strainer and butt from the same manufacturer and era) are what collectors expect to see on an honest drum.

Adjustable butts allow fine wire tension from both ends; fixed plates are period-correct for earlier drums. Either way, confirm the mounting holes line up with your shell's drilling before ordering — re-drilling for a mismatched butt halves the value it was meant to protect.

Every Snare Butt Plates piece below is in stock now — one-of-a-kind, photographed, and honestly graded. When a piece sells it moves to the archive, so this page always shows exactly what is available.

What the catalog holds: Snare Butt Plates

22 pieces in stock · 225 in the archive.

Common lug hole spacings: 2 3/8" (4), 1 1/2" (1), 2" (1), 2 7/16" (1) — match your shell drilling exactly.

Every figure above is measured from photographed specimens — live stock plus the archive of past listings — not from a catalog or a price guide.

Frequently asked questions

How do I match a butt to my throw-off?

Maker and era first — strainer and butt from the same manufacturer and era are what collectors expect — then mounting-hole alignment center-to-center against your shell drilling.

Adjustable or fixed butt — which is correct?

Adjustable butts allow fine wire tension from both ends on later drums; fixed plates are period-correct for earlier shells. Buy the design that agrees with your drum's era.

What should I check on a used butt?

Stripped threads, bent ears, and cracked frames under constant wire tension. A butt that cannot hold tension is a replacement, not a restoration — price it accordingly.

Will any butt fit my shell?

Only when its holes line up with your shell's drilling. Re-drilling for a mismatched butt is the value damage the part was meant to prevent — confirm alignment before ordering.

Collector guides & data

Deep dives measured from the same catalog snapshots as the figures above: